You are not logged in.    Log In | Join Now

Vl Missing

Forum » VL Discussion » Vl Missing

Vl Missing

24 Feb 10, 6:56pm
brandon
Posts: 8
I got a vl turbo wagon and its missing it idle but the rev's go up and down and i put my foot down to rev it and its got a flat spot can u guys help me out thanks?
24 Feb 10, 11:55pm
ian pache
Posts: 2
check the plugs and the air flow meter
26 Feb 10, 6:21pm
Lord-GMH
Posts: 134
i had that the other day it timeing or your injectors it was for me jectors are 300 each and timiing was easy lol i think its a vl thing cos this is my 2nd vl and they both did it also wat ian pache said the sparkys
27 Feb 10, 7:00pm
brandon
Posts: 8
We have replaced plugs and i put a new fuel fitter and its still doin it so any idea need help asap please?
27 Feb 10, 9:35pm
Paul
Posts: 3
This sounds like 2 things one is the AFM the other is checking all piping make sure there all tight no leaks u can do a test on the ecu to c if the AFM is faulty remove left kick panel ecu is just behind that there's a little turning knob in a hole flathead screw driver turn knob fully anti clock wire this puts the ecu in diagnosis mode the start the car and count how many reds flash then green if l remember right reds are ten greens are one so eg 2reds and 4greens that's 24 it tell u all this in the manual cheers hope u get it sorted
04 Mar 10, 8:52pm
brandon
Posts: 8
I have check all of the fuel pump but 1 i will do that tommorow this car is really starting to p!ss me off once i start the car it revs normal but once u start to get up it it just dies and has flat stops and once u try and drive it theres no power feels like the handbrake is on i have been told it could be CAS but does you car still run if its stuffed I need help asap Thanks Brandon
08 Mar 10, 9:17pm
lowrydr
Posts: 5
hey dude ya my wag doing the same thing it coughs and spultors then back fires ive done all the leads new plugs and dizzy cap aswell as new fuel pump and filter, and now it doesnt even wana turn over. HELP
wat do i look for now ive changed the starter and still nothing, Sumbody give nxt step and is the Crunk angle sensor going to make i run like shit?????
16 Mar 10, 9:07pm
brandon
Posts: 8
Update:changed the iner fuel pump and found out the piping to the turbo had come off so did that and worked fine yesterday now today went to go for a drive and wont even crank everthing works so idn changin starter motor tommorow so see wats happens spend't so much money on it and its goin now where.
18 Mar 10, 1:46pm
Lord-GMH
Posts: 134
Have you tryed ur relays or ur ecu could have overloaded you got fuel in ur car im asuming you checkd the wiring make sure your plugs , clips n wires arnt freyd id say relays i neeeded a ignition relay.

 
Home | VL Customiser | VIN Decoder | VL Turbo Nationals | Browse Tags | Privacy Policy | Contact